How to Fix Sticky Car Disc Brakes

A stuck or sticky disc brake is certainly one of the most common problems with disc brakes. But of course the damage to the disc brakes can not be left alone. This is because the brake function is related to safety while driving. So when the car brakes have problems, of course it will be very dangerous for you to drive the car. For this reason, it is important to immediately make repairs if there is damage to your car. But before knowing how to fix a sticky car disc brake, then you should know about the causes of this damage.

One of the causes that often occurs is a jammed brake master. Usually this happens because the rubber dust retainer is damaged, causing dust to enter and mix with water which then dries and causes rust.

Rusty brake pistons or stuck caliper pens can also be the cause. This prevents the piston from re-entering the piston housing when the brake pedal is released. The function of the pen caliper here is as a place for the piston housing to move back and forth during the braking process. If this component is jammed, of course the braking process will be hampered. Dirty piston disc conditions also cause the car's disc brakes to become sticky.

Another cause could be because the piston disc has been damaged, causing the piston's performance to be not optimal and elastic.

Then how to deal with sticky car disc brakes easily? Here's the explanation.

1. Wheel Jack

The first thing you can do is jack up the front of your vehicle until the front wheels lift. Make sure the condition of the hand brake is pulled by supporting the rear tire. Turn the front wheels right and left, feel if there are parts that feel drag or stuck. Normally if there is no problem with your car's disc brakes, then the wheels can spin smoothly without a hitch. But if it feels dragged and even stuck, then there must be damage in it. Then disassemble the tire so that it can be investigated more deeply about the cause of disc brake damage.

2. Start Cleaning the Brakes

Once you start disassembling the braking system, then the next thing you should do is start cleaning the brakes. Clean the brakes thoroughly until they are clean but still thorough. Do not clean with water, use gasoline to clean effectively. After that wipe using a clean and soft cloth. If there is rust in it, you can try using a special rust remover solution and it is also important to know how to remove rust from a car.

3. Check the Disc Brake Calipers

If the condition of rust and dirt is free from the components in the brake, then the next thing to check is the caliper pen on the disc brake. The function of this component is as a place for the piston housing which works back and forth when the brake pedal is stepped on. If this component is jammed, then of course the piston housing cannot return to its original position when braking is done. To check it yourself, you can try it easily by removing the brake pads and then putting them back in without using brake pads.

After that, ask a friend or another for help to step on the brake pedal slowly until the piston comes out. After that push it using a screwdriver. When the piston is pushed but cannot re-enter, it is certain that the piston is damaged. In addition, you can also check it by moving the piston housing back and forth, if the piston housing cannot move freely, it indicates if there is damage that must be repaired by replacing a new one.

4. Replace With New Parts

After checking, of course, it is necessary to replace several components that require replacement, such as beige cups, brake cylinders, brake linings, and others. If it is time for this component to be replaced, it should be replaced immediately. Replace with new components and according to the specifications of your car.

5. Reinstall Carefully

After all components are cleaned and replaced, then reinstall all components to their original positions. But remember, install it carefully and don't rush. Install it carefully and don't misplace it.

6. Change Brake Oil

Not only that, another way to deal with sticky car disc brakes can be done by replacing the old brake oil with a new one. Do pumping brake oil until the dirty brake oil can come out all until only clean brake oil remains. Do this until all the air in it is out and the brakes can work perfectly.